Reprap calibration: Bottom, the First Layer and Z-Home
in 3D Printing
Some links on this page go to Amazon. As an Amazon Associate I earn from qualifying purchases.
Some links on this page go to Amazon. As an Amazon Associate I earn from qualifying purchases.
A few days back, I saw the post on Hackaday about how you can solder a USB cable and some components on the powerbutton/wireless module from a XBOX 360 and use it as a host for wireless controllers on your PC.
This post is cloned from http://www.mp3car.com/forum/general/show-off-your-project/86872-2000-jeep-cherokee-carputer-install-worklog
this post is cloned from http://www.mp3car.com/forum/mp3car-technical-hardware/car-audio/72803-radioshark-to-car-antenna/page2